PlainRecalls
No agency classActive

CPSC recall · Reported March 26, 2002

CPSC, Invensys Climate Controls Announce Recall of TS11 Thermal Safety Control Valve

The lower body, with 1/4", 3/8", 7/16" inlet/outlet diameter, may have a machining defect that can create a thin wall on the bottom of the casting. The cast area may break through…

Recall #
02527
Affected scope
18,200
Verify with CPSC →
View my saved recalls

Invensys Climate Controls - Oem Products Group, of Long Beach Calif., a division of Invensys Control Systems recalled The affected units were manufactured between June 2001 and August 2001 and have productio….

CPSC, Invensys Climate Controls Announce Recall of TS11 Thermal Safety Control Valve was recalled by Invensys Climate Controls - Oem Products Group, of Long Beach Calif., a division of Invensys Control Systems in March 26, 2002. Reason: The lower body, with 1/4", 3/8", 7/16" inlet/outlet diameter, may have a machining defect that can create a t…. Remedy: Consumers who have one of these valves should return to the point of purchase or to Inven…. Verify recall #02527 with the CPSC before acting.

The recall

Invensys Climate Controls - Oem Products Group, of Long Beach Calif., a division of Invensys Control Systems issued this CPSC recall-The lower body, with 1/4", 3/8", 7/16" inlet/outlet diameter, may have a machining defect that can create a t….

None
agency class
18K units
affected scope
March 26, 2002
reported

Sourced from official CPSC enforcement records. Verify recall #02527 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.

Recall Insight

This recall's affected scope, documented in the Recall Profile below, stays within a single-region or limited-distribution footprint. Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. Consumers holding this product should act on the agency's documented remedy above rather than relying on general guidance.

Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.

Appliances recalls over time

Where this recall sits in its category - 426 appliances recalls on record

0102030405060 20052008201120142017202020232026 16

Product description

The affected units were manufactured between June 2001 and August 2001 and have production dates beginning with codes 0124 through and including 0131. The date codes are marked on the backside of the upper housing, below the red button. Invensys Customer Model / Appliance Number Customer Part Number Invensys Part Number American Wyott (included in Vulcan Hart) 2065611 512-110-112 American Range AR Series Ranges 10425 or A80100 511-100-201 Cecilware Co. L344A 512-110-102 Comstock Castle 13017 511-110-201 Duke Manufacturing Aerohot and Thurmaduke Gas Foodwarmer products 21-35-08 511-100-222 Dynamic Cooking Systems Professional Restaurant Ranges 13002 511-100-001 Garland Commercial & US Range Garland Starfire H280 series US Range Sunfire S series US Range Performer PX series US Range Cuisine 836 series GO1479-01 511-112-401 GLT Inc. (included in Vulcan Hart) 920442 512-110-520 405969-2 511-121-520 Imperial Manufacturing IR,IHR and ISAE series 2138 511-100-201 Jade Range 460-152-000 511-100-001 Mecserflex Ltd. None 511-110-001 Monague Co. 511-111-508 511-111-516 Royal Range Ind. None 511-100-222 Shenandoah Mfg. Co. 10421100 511-100-401 Vulcan Hart-PMI Heavy Duty Restaurant 427083-2 511-115-001 Heavy Duty Restaurant 405569-2 511-121-520 Heavy Duty Restaurant 920442 512-110-520 Wolf Range Heavy Duty Restaurant 714267 511-100-001 920442 512-110-520 Industrias Baal S.A. de C.V. None 511-100-001 Maplechase/ Uniline Uniline Part Number Invensys Part Number Canada 1731-C110 511-110-001 Canada 1731-C112 512-110-101 US 1710-11A 14111 US 1710-11B 14112 US 1720-00F 1720-006 511-112-201 US 1720-00H 1720-008 511-100-001 US 1720-00D 1720-004 511-121-520

Reason for recall

The lower body, with 1/4", 3/8", 7/16" inlet/outlet diameter, may have a machining defect that can create a thin wall on the bottom of the casting. The cast area may break through partially or completely in a circular pattern when rapped, causing an external leak. The leaking gas may cause a fire.

Remedy, what to do

Consumers who have one of these valves should return to the point of purchase or to Invensys.

Recall Profile

Structured summary of the CPSC recall record
Attribute Value
Agency U.S. Consumer Product Safety Commission
Severity class Not classified by agency
Status Active
Recall number 02527
Date reported March 26, 2002
Date initiated March 26, 2002
Recalling firm Invensys Climate Controls - Oem Products Group, of Long Beach Calif., a division of Invensys Control Systems
Affected scope 18,200
Distribution Not disclosed
Official source CPSC notice →

Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.

Scale of Impact

18,200 units affected - limited or regional distribution scale.

Regional (<10K units) -
Multi-state (10K – 100K units) ✓ This recall
Large-scale (100K – 1M units) -
Massive (≥1M units) -

Bracket cutoffs follow federal recall-disclosure conventions; bar widths scale linearly within each bracket. Source: PlainRecalls analysis of U.S. Consumer Product Safety Commission filings.

What to do with this recall

Consumers who have one of these valves should return to the point of purchase or to Invensys.

  • Check the recall number (02527) and product description against the item you own. Search the archive
  • Confirm the current status and remedy on the official CPSC notice before acting. CPSC notice
  • Follow the documented remedy (refund, replacement, repair, or disposal) rather than general advice. What to do next

This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.

Frequently Asked Questions

What product was recalled?
The affected units were manufactured between June 2001 and August 2001 and have production dates beginning with codes 0124 through and including 0131. The date codes are marked on the backside of the upper housing, below the red button. Invensys Customer Model / Appliance Number Customer Part Number Invensys Part Number American Wyott (included in Vulcan Hart) 2065611 512-110-112 American Range AR Series Ranges 10425 or A80100 511-100-201 Cecilware Co. L344A 512-110-102 Comstock Castle 13017 511-110-201 Duke Manufacturing Aerohot and Thurmaduke Gas Foodwarmer products 21-35-08 511-100-222 Dynamic Cooking Systems Professional Restaurant Ranges 13002 511-100-001 Garland Commercial & US Range Garland Starfire H280 series US Range Sunfire S series US Range Performer PX series US Range Cuisine 836 series GO1479-01 511-112-401 GLT Inc. (included in Vulcan Hart) 920442 512-110-520 405969-2 511-121-520 Imperial Manufacturing IR,IHR and ISAE series 2138 511-100-201 Jade Range 460-152-000 511-100-001 Mecserflex Ltd. None 511-110-001 Monague Co. 511-111-508 511-111-516 Royal Range Ind. None 511-100-222 Shenandoah Mfg. Co. 10421100 511-100-401 Vulcan Hart-PMI Heavy Duty Restaurant 427083-2 511-115-001 Heavy Duty Restaurant 405569-2 511-121-520 Heavy Duty Restaurant 920442 512-110-520 Wolf Range Heavy Duty Restaurant 714267 511-100-001 920442 512-110-520 Industrias Baal S.A. de C.V. None 511-100-001 Maplechase/ Uniline Uniline Part Number Invensys Part Number Canada 1731-C110 511-110-001 Canada 1731-C112 512-110-101 US 1710-11A 14111 US 1710-11B 14112 US 1720-00F 1720-006 511-112-201 US 1720-00H 1720-008 511-100-001 US 1720-00D 1720-004 511-121-520. Recalled by Invensys Climate Controls - Oem Products Group, of Long Beach Calif., a division of Invensys Control Systems. Units affected: 18,200.
Why was this product recalled?
The lower body, with 1/4", 3/8", 7/16" inlet/outlet diameter, may have a machining defect that can create a thin wall on the bottom of the casting. The cast area may break through partially or completely in a circular pattern when rapped, causing an external leak. The leaking gas may cause a fire.
What should consumers do?
Consumers who have one of these valves should return to the point of purchase or to Invensys.
Which agency issued this recall?
This recall was issued by the CPSC on March 26, 2002. CPSC does not publish a hazard classification for this recall. Recall number: 02527.
How do I report an injury from a recalled product?
Report injuries to the issuing agency: CPSC at SaferProducts.gov, NHTSA at nhtsa.gov/report-a-safety-problem, or FDA via MedWatch. Document the product (photos, model/serial numbers, purchase receipts) and seek medical attention. Injury reports help agencies track hazard patterns and may strengthen enforcement actions.

Nationwide recalls with similar severity or category timing

Consumer-product notices outside this firm and state, matched by severity timing and product category.

Compare this recall with Modine Manufacturing Company Recalls Airedale Heating and C… → · All Appliances recalls

This recall: CPSC, reported March 26, 2002. Severity classes follow each agency's own taxonomy; related-recall context is computed across the full archive.

Methodology · Corrections · Archive as of August 2026