Severity
Moderate
CPSC recall · Reported April 26, 2007
The right and left front suspension shock towers can separate due to inadequate welding during the manufacturing process. Separation of the welded joints can result in stiffer ste…
Polaris Industries Inc., of Medina, Minn. recalled Only 2006 model year Polaris snowmobiles are part of this recall. The model and serial nu… - a moderate-severity action.
Polaris Industries Inc. Recalls Snowmobiles Due to Loss of Control Hazard was recalled by Polaris Industries Inc., of Medina, Minn. in April 26, 2007. Reason: The right and left front suspension shock towers can separate due to inadequate welding during the manufactur…. Remedy: Consumers should stop using their snowmobile immediately and contact their Polaris dealer…. Verify recall #07543 with the CPSC before acting.
The recall
Polaris Industries Inc., of Medina, Minn. issued this moderate-severity CPSC recall-The right and left front suspension shock towers can separate due to inadequate welding during the manufactur….
Sourced from official CPSC enforcement records. Verify recall #07543 with the agency before acting. Full product description, hazard, remedy, and related recalls are below.
This CPSC action (record #07543) was formally reported on April 26, 2007. It is classified under Moderate severity, with a current status of Active. Polaris Industries Inc., of Medina, Minn. is listed as the recalling firm. Federal records list the affected scope as About 2,700.
The documented reason for this recall is: The right and left front suspension shock towers can separate due to inadequate welding during the manufacturing process. Separation of the welded joints can result in stiffer steering or the shock mount failing suddenl… Distribution information was not included in the agency filing, so consumers should assume broad potential exposure until the firm publishes point-of-sale details. The remedy documented by the agency is: Consumers should stop using their snowmobile immediately and contact their Polaris dealer to schedule an appointment for a free repair. The dealer will install a kit that will replace the original sh… - consumers holding this product should act on that instruction rather than relying on general guidance.
Within the same product category the archive holds 6 closely related recalls, 6 from CPSC - clustering in a narrow category often points to a systemic quality-control or supplier issue rather than a one-off defect. Always verify the recall number against the official agency record before acting.
Where this recall sits in its category - 7,642 vehicles recalls on record
Of 101,704 recalls in the database, 24,878 are high severity, 72,426 moderate, and 4,400 low. This recall is classified moderate severity.
Counts reflect market size and reporting activity, not inherent danger, we do not rank products by risk from raw recall volume.
Severity
Moderate
Affected scope
About 2,700
Related Recalls
6
6 from same agency
Only 2006 model year Polaris snowmobiles are part of this recall. The model and serial number identification decal is located on the right side of the tunnel underneath the seat. The recalled model names and numbers are listed below. Models Affected Model Numbers 2006 FS Classic S06PD7ES 2006 FST Classic S06PD7FS/S06PD7FE 2006 FS Touring S06PT7ES 2006 FST Touring S06PT7FS 2006 FST Switchback S06PS7FS/S06PS7FE
The right and left front suspension shock towers can separate due to inadequate welding during the manufacturing process. Separation of the welded joints can result in stiffer steering or the shock mount failing suddenly, causing the rider to lose control of the snowmobile and crash.
Consumers should stop using their snowmobile immediately and contact their Polaris dealer to schedule an appointment for a free repair. The dealer will install a kit that will replace the original shock towers with new versions. Polaris has directly notified registered consumers with units involved in this recall.
| Attribute | Value |
|---|---|
| Agency | U.S. Consumer Product Safety Commission |
| Severity class | Moderate |
| Status | Active |
| Recall number | 07543 |
| Date reported | April 26, 2007 |
| Date initiated | April 26, 2007 |
| Recalling firm | Polaris Industries Inc., of Medina, Minn. |
| Affected scope | About 2,700 |
| Distribution | Not disclosed |
| Official source | CPSC notice → |
Profile values are sourced directly from the official CPSC enforcement record. Source: U.S. Consumer Product Safety Commission.
What to do with this recall
Consumers should stop using their snowmobile immediately and contact their Polaris dealer to schedule an appointment for a free r…
This page summarizes the official CPSC record for research and awareness; it is not legal, medical, or safety advice. Verify with the issuing agency before acting.
Other recalls in the same product category, useful for spotting patterns across the same defect class or manufacturer.
Yongkang Ruihe Metal Products Co. Ltd., of China · 2026-06-25
· 2026-06-18
CooCooBaby, of China · 2026-06-18
Kawasaki Motors Manufacturing Corp., U.S.A., of Lincoln, Nebraska · 2026-06-11
· 2026-06-11
Compare this recall with Yamazuki Recalls Youth All-Terrain Vehicles (ATVs) Due to R… →
Every figure on PlainRecalls is rendered directly from official FDA, CPSC and NHTSA recall records, no number is typed in by an editor. This recall: CPSC, reported April 26, 2007. Severity classes follow each agency's own taxonomy (FDA Class I/II/III; CPSC and NHTSA by hazard type), and related-recall context is computed across the full archive. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of July 2026.